The RATS Software Forum

Dear Tom,

I hope this finds you well,

Would you kindly tell me how to change the format of graphs generated by procedures like @MCGraphIRF. I would like to increase the font of vertical axis figures.

Thank you and best regards.

Then change them. The following is in the procedure:

grparm(bold) hlabel 18 matrixlabels 14
grparm axislabel 24

Those are all relative to the size of the graph. If you find one too small, increase it.

Thank you for your reply.

And for the titles of the graphs, I would like to increase their size, they remain unchanged, when i change these parameters.

Thank you

The header? You can add a change to the HEADER to the first of the two GRPARM's. The default is 24.

Dear Tom,

Yes, it's not what convenient to resort to one graph per page, but what could I do if I have graphs that I can't present in a word document, I tried to modify the options in the procedure @MCGraphIRF, but I still have graphs that I can't read one I copy to word, see attached.

I ended with grparm(bold) hlabel 60 matrixlabels 18
grparm axislabel 34
*
Would you give me some hints.

Thank you very much

I suggested that you change the size of HEADER, not HLABEL. There are no HLABEL's in that graph.

Thank you.

and what about the lines of the graphs, how could I change their format?

See section 3.16 of the RATS Introduction.