The RATS Software Forum

I read some old code using cross() series1 series2 -nstep nstep var3
I did not see declaration of nstep, so is it an old version?
In the manual it says there was ones but did not specify.
nstep=min(T/4，2sq(T))?

Thanks

ivory4 wrote:I read some old code using cross() series1 series2 -nstep nstep var3
I did not see declaration of nstep, so is it an old version?
In the manual it says there was ones but did not specify.
nstep=min(T/4，2sq(T))?

Thanks

The new way to do that is:

cross(from=-nstep,to=nstep,results=var3) series1 series2

nstep is still reserved name here right?

No. If you leave off the FROM and TO, you get from -min(2sqrt(N),N/4) to +min(2sqrt(N),N/4)